24.03.2020
Schmierung Fettschmierung mit Fettpressen oder Progressivanlagen Schmierung Tabelle 1 Größe Erstschmierung (Normalhub) Materialnummer (nicht erstbefettet) Materialnummer (erstbefettet) R16.. ... 10 R2
Dateityp: application/pdf
Verlinkt bei:
24.03.2020
Lubrication Lubrication using a grease gun or a progressive feeder system Lubrication Table 1 Size Initial lubrication (normal stroke) Material number (not initially greased) Material number (pre-lubr
Dateityp: application/pdf
Verlinkt bei:
13.03.2020
ROTEX® GS Betriebs-/Montageanleitung KTR-N Blatt: Ausgabe: 45510 DE 1 von 40 23 Schutzvermerk ISO 16016 beachten. Gezeichnet: 10.02.2020 Pz/Ht Ersatz für: KTR-N vom 10.04.2019 Geprüft: 10.02.2020 Pz E
Dateityp: application/pdf
Verlinkt bei:
26.03.2020
Schmierintervalle / -mengen Kugelgewindetriebe Lubrication intervals / quantities Ball screw drives Schmierintervalle / Lubrication intervals: KGT 12xx bis 32xx nach ca. 2,5 x 10 7 Überrollungen / KGT
Dateityp: application/pdf
Verlinkt bei:
18.10.2022
Schmieranschluß Lineareinheiten Beta Lubrication connection linear units Beta K / us / 23.03.2020 geändert: us / 12.10.2022 1HSB Automation GmbH In Laisen 74 72766 Reutlingen Telefon: +497121/14498-0
Dateityp: application/pdf
Verlinkt bei:
03.04.2020
Critical revolution – Spindle supports The critical revolution is the revolution at which a ball screw exhibits resonance. With a rotating spindle, the maximum revolution is determined by the so-calle
Dateityp: application/pdf
Verlinkt bei:
03.04.2020
Buckling strength Mechanical linear drives with a screw drive, which are installed vertically, must also be tested with regard to the buckling strength if they are installed with the fixed bearing fac
Dateityp: application/pdf
Verlinkt bei:
03.04.2020
Mass moment of inertia for connecting elements Weight of joint shaft GX Rotex GS couplings Size KN SRN-S SRN-L ZKR [ ] 9 0.49 x 10-6 - - 0.085 x 10-6 12 1.3 x 10-6 - - 0.139 x 10-6 14 2.8 x 10-6 - 0.0
Dateityp: application/pdf
Verlinkt bei:
03.04.2020
Load ratings for rail guides (SF) per guiding carriage Guide size Description Vsp C50 CDIN Description Vsp CDIN [] [] [N] [N] [N] [] [N] [N] 15-B 15 SHS15V 564 14200 11271 R1622-123-20 620 9860 20-B 2
Dateityp: application/pdf
Verlinkt bei:
03.04.2020
General The purpose of pretension is to guarantee a minimum tension force in the slack strand in order to ensure smooth engagement in the driven disc. The set pretension should generally only be as hi
Dateityp: application/pdf
Verlinkt bei: