14498-0 Fax +49 7121 14498-10 Info@HSB-Automation.de www.HSB-Automation.de Original Assembly and Maintenance Instructions Portal linear unit Types Sigma 70-ZRS Sigma 90-ZRS Sigma 120-ZRS Sigma 160-ZRS Safety [...] ....................................................................................... 15 10 Maintenance .............................................................................................. [...] liability for any unauthorised changes carried out on the unit. The operator may only carry out the maintenance and repair work specified in these Operating Instructions. Any further work involving the replacement

Dateityp: application/pdf
Verlinkt bei:

14498-0 Fax +49 7121 14498-10 Info@HSB-Automation.de www.HSB-Automation.de Original assembly and maintenance instructions Ball screw General FM 225 A&M instructions for ball screw, rev.01 2018-10-18 1 Table [...] FM 225 A&M instructions for ball screw, rev.011 1 General 1.1 Introduction These assembly and maintenance instructions (A&M) are intended for persons with the necessary expertise, such as installers, users [...] system operators. They contain important information regarding how to assemble, operate, carry out maintenance on and dismantle the product safely and correctly and how to rectify simple faults yourself. They

Dateityp: application/pdf
Verlinkt bei:

data on the amounts of grease and lubrication intervals can be found in the “Installation and Maintenance Manual” as well as on the Internet under www.hsb-automation.de. * ≙ Revolutions of the spindle Operating [...] Technical Data Maximum Drive Torques Maintenance Chapter KGT Ball Screws Ordering Code Chapter KGT Technology General Technical Specification Calculations Installation Maintenance Technical Data for the Design [...] Guides and Ball Screws TL 14 – TL 16 Technology Linear Maximum Drive Torques TL17 Technology Linear Maintenance K1 KGT Rolled ball screw spindles K2 KGT Cylindrical ball screw nuts HSB (KGM-M) K3 – K4 KGT Ball

Dateityp: application/pdf
Verlinkt bei: